Dry contacts are prohibited within ___ NM of weather that is known or suspected to be producing lightning
30
25
20
15
With minimum crew, if the boom is powered on but still stowed; can you get up to use the restroom?
Yes
No
During takeoff, the center tank may contain up to _______ pounds of fuel with less than full main tanks provided center tank fuel weight plus actual zero fuel weight does not exceed the maximum zero fuel weight, and CG limits are observed.
22,050
22,000
18,500
21,050
Use of APU bleed air above _______ feet pressure altitude is prohibited
Cabin altitude, Rapid Depressurization, Smoke, Fire or fumes
What must the tanker declare with ATC before conducting AAR operations?
Current altitude
Altimeter setting
Timing
MARSA
When do shoulder harnesses need to be fastened?
Always
Takeoff, taxi and landing
Critical phases of flight
Air refueling
Minimum taxiway width?
76
80
72
74
What type of landing gear does the KC-46 have?
TT
2D
SBTT
TRT
Maximum crosswind component is ___ knots with direct IP supervision, and ___ knots for ACs
25 , 10
20 , 15
25 , 15
15 , 20
Maximum headwind component for manual landing is ___ knots
25
10
30
No limit
Maximum headwind component for autoland is ___ knots
25
10
30
No limit
Maximum tailwind component for take-off and landing is ___ knots
10
25
15
20
Maximum crosswind for take-off is ____ knots
32
29
25
10
Maximum operating altitude?
40,100
40,000
42,000
39,500
Minimum runway length?
7,000
5,000
7,500
6,500
Tripped circuit breakers may be reset once, after a short cooling period of how many minutes
1
3
2
4
Flight crew reset of a tripped fuel pump circuit breaker or fuel pump control circuit breaker is
permitted
prohibited
During flap retraction, selection of the next flap position is initiated when reaching the maneuver speed for the existing flap position and the target speed is at or above the next flap maneuver speed.
True
False
The master WARNING lights and fire bell are inhibited for fire during part of the takeoff. The inhibit begins at
Takeoff clearance
Application of intial takeoff thrust
V1
60 knots
The inhibit continues until
600 feet radio altitude or 30 seconds after V1
400 feet radio altitude or 25 seconds after V1
200 feet radio altitude or 15 seconds after V1
500 feet radio altitude and 20 seconds after V1
The fuel off button is able to be used when in contact during WARPS refueling
True
False
Breakaway indications made by pressing the breakaway switch on the telescope control stick include
Flashing PDL's background and signal segments for 10 seconds
Breakaway signal sent to PFD's
Initiates an aural annunciation in the flight deck
All of the above
_____________ procedures should be initiated any time RVS imagery is not satisfactory
Breakaway
Disconnect
Disconnect and/or breakaway
Scene change
When accomplishing the boom flight control check the boom must reach 18 to 40 in elevation and 0 to 20 in left and right roll
True
False
How much fuel is needed in the center tank to complete the boom fill procedure?
5,000
4,500
5,500
6,000
In what order are RAIS messages displayed?
Advisory, Caution, Warning
Caution, Warning, Advisory
Warning, Advisory, Caution
Warning, Caution, Advisory
A system fault reset will clear all ___________ , allowing for the system to re-evaluate its state
RAIS messages
Boom system faults
EICAS messages
Warning / Caution annunciations
A receiver initiated disconnect will advance the signal state from contact to disconnect in manual override mode
True
False
A blinking boom STOWED indicates that
Stow has been commanded and the boom latch is closed
Stow has been commanded and the boom latch is open
What type of disconnect is commanded during an automatic limit disconnect?
Normal
IDS
Both
When the ENV LIMITS switch is set to off, which limits will still remain active?
Elevation and telescope position and rate limits
Roll position and rate limits
Where are the ALAS sensors located?
Near the boom latch
Tail cone assembly
Ruddevators
The end of the telescoping tube, forward of the nozzle
Signal amplifier coil short and coil open tests are performed upon Reset-to-Ready command
True
False
Functions of the ACU include signal management and processing for
Flight control stick and telescope stick inputs
Fuel pressure sensors
Emergency retract
All (but not limited to) the above
The ___ is the avionics computer that provides direct control of the boom actuators
ACU
ACS
SDCN
ARCC
The ____ is used to operate the boom during in-air refueling operations
ACU
ACS
SDCN
ARCC
During the preflight check of a crew oxygen mask, a pressure decrease may indicate
There is a pressure decrease
Oxygen cylinder pressure is low
MX broke something
The crew oxygen cylinder shutoff valve is closed
The smoke goggles for the flight deck are located
Attached to all of the quick dons
Behind the seats
Near the crash axe
The boom is hiding them from you
The smoke goggles at the AROS station are located
On the quick don masks
Drop down from the ceiling
Under the seats
Behind the seats
The "passenger style" masks that are automatically presented in the event of cabin depressurization are located at
The crew seats in the ACMC
The flight deck
Crew bunks / Aft attendant seats / Lavatory
AROS Station
________ oxygen generators supply oxygen to the oxygen masks in the lavatory and at each crew bunk
High pressure
Liquid
Chemical
Gaseous
The Main Deck Oxygen System is comprised of ___ high-pressure oxygen cylinders