Table Saw
star
star
star
star
star
Last updated over 1 year ago
11 questions
Required
4
Other Answer Choices:
Fence
Angle adjustment
Power switch
Height adjustment wheel
Required
1
You should never cut free hand. Always use a fence, miter gauge, or jig/fixture.
You should never cut free hand. Always use a fence, miter gauge, or jig/fixture.
Required
1
You should stand to the right of the blade while operating this saw.
You should stand to the right of the blade while operating this saw.
Required
1
You are not required to use a push stick if your hand if over four inches from the blade (though there may be times you might still use one)
You are not required to use a push stick if your hand if over four inches from the blade (though there may be times you might still use one)
Required
1
When rip cutting, you must use the ____.
When rip cutting, you must use the ____.
Required
1
When cross-cutting, you must use the _____.
When cross-cutting, you must use the _____.
Required
1
When tailing off for a partner, I can help by pulling hard on the piece being cut.
When tailing off for a partner, I can help by pulling hard on the piece being cut.
Required
1
The only thing that should be on the blade side of the fence is the piece you are actively cutting.
The only thing that should be on the blade side of the fence is the piece you are actively cutting.
Required
1
It is safe to reach for small scraps near the blade while the blade is spinning (even if I turned the machine off).
It is safe to reach for small scraps near the blade while the blade is spinning (even if I turned the machine off).
Required
1
I should use the fence for cross-cutting and the miter gauge for rip cutting.
I should use the fence for cross-cutting and the miter gauge for rip cutting.
Required
1
The saw blade should be 1/8 of an inch above the piece I am cutting.
The saw blade should be 1/8 of an inch above the piece I am cutting.